To open the Delay section, click the Delay button. At the highest setting, nearly all of the information describing the original audio signal is eliminated, turning the signal into unrecognizable noise. Sets the amount by which the audio samples are decimated. Modes I and III are nastier and noisier, while modes II and IV are more subtle. In each mode, the plug-in sounds differently. ModeĪllows you to select one of the four operating modes. The lower the resolution, the higher the distortion effect. DecimatorĬontrols the resulting bit-resolution.
This band mode allows you to decimate and truncate the input audio signal to create a noisy, distorted sound. You can select the following types of guitar amps: DriveĬontrols the amount of amp overdrive. This band mode simulates the sound of various types of guitar amps. Higher settings increase the distortion effect. Driveįeeds part of the output signal back to the effect input. This band mode adds distortion to your tracks. Tubesĭetermine the number of tubes that are simulated. DriveĬontrols the amount of tube saturation.
This band mode simulates the saturation effects using analog tubes. DriveĬontrols the amount of tape saturation. This band mode simulates the saturation and compression of recording on analog tape machines. Signal levels above the set threshold trigger the gate to open, and signal levels below the set threshold close the gate. In/Out meterĭetermines the level at which the gate is activated. To solo a frequency band, activate the S button in each section. To bypass each frequency band, activate the Bypass Band button in each section. To mute each frequency band, activate the M button in each section. Sets the level balance between the dry signal and the wet signal. You can automate the selection of scenes. To copy the settings of a scene to another scene, select the scene that you want to copy, click Copy, and click one of the numbered buttons.
If you change the default settings, the button lights up green, indicating that this scene has customized settings. If the default setting of a scene is active, the selected scene button lights up yellow. Switches between multi band and single band mode. To attenuate or boost the output level of each frequency band by ☑5 dB, use the handles on top of each frequency band.
To define the frequency range of the different frequency bands, use the handles at the sides of each frequency band. The horizontal scale shows the available frequency range. The vertical value scale to the left shows the gain level of each frequency band. The frequency band editor in the upper half of the panel is where you set the width of the frequency bands as well as the output level.
0 kommentar(er)
